Smart Lighting
High-side driver ASSP controls LEDs, relays
AMI Semiconductor has expanded its family of high-side driver ASSPs with a new device designed specifically for the control of LEDs, relays, solenoids, transistor gates, valves, and other loads in industrial systems.
Published by LED professional ·
Qualified for operation up to 28V and suited to designs with nominal system supply voltages of 24V, the AMIS-39101 integrates into a single SO28 package eight high-side output drivers and a range of functions and features designed to significantly reduce component count and cost. Built-in functionality includes an SPI for direct connection to an MCU, an integrated diagnostic circuit, and short circuit and thermal overload protection.
Protection circuitry
Each of these device`s high-side drivers will drive a continuous current of 275mA when connected to an inductive load of 300mH. Higher individual output currents are possible by limiting device current to the total maximum. The drivers will withstand short circuits to the power supply or to ground, respectively, even in situations where the device itself has lost its ground connection. The drivers also provide overcurrent limitation and in the case of a fault condition are switched off. The AMIS-39101 features over-temperature protection circuitry and is self protected against thermal runaway, even at low power supply voltages.
Diagnostic circuit
Compatible with 3.3V and 5V MCUs, the SPI interface is used to control each of the individual output drivers and to provide a route for the integrated diagnostic circuit to feedback error signals. The interface can also be used to read back the status of the built-in thermal shutdown protection function.
The AMIS-39101 ASSP incorporates a power down mode to reduce power consumption during non-active periods and uses an integrated slope control function that ensures low electromagnetic emission. Operating temperature is rated at -40°C to 80°C.
The AMIS-39101 is available today at $2.07 each for 1,000 pieces.
